In the aviation industry, it has higher requirement, not only the spare parts material should be light, but also it can bear extreme load in bad environment. By virtue of protecting the surface of spare parts from exterior destroy and extend the lifetime, our surface treatment can improve the whole performance of spare part.

Digital control shot blasting application:

Fatigue- by virtue of implanting extrusion stress to effectively control the production of the fatigue split.

Mild wear-mild wear can result in the fatigue damage, suitable shot blasting can improve the surface contact of parts and produce extrusion stress on the surface, so as to decrease the mild wear.

Stress corrosion split-decrease the surface stretch stress or make it lower than the critical point to remove split caused by stress corrosion.

Most of the spare parts used in aviation industry, including airplane frame, wings, motors, landing gear, driving device, or transmission parts( gear); all adopt shot blasting treatment to meet its performance specifications.

shot blasting machine for airplane parts

Manual and automation integrated super fine sandblasting machine for airplance motor parts

Digital control shot blasting formed machine tool

Shot peening is a good way to form a complicated air power curve. This process without the module for the formation of airplane wing is ideal. It can also be used to remove the distortion of complicated parts due to processing or hot treatment.

Shot peening is a good way to form the complicated air drive curve, this is the ideal process to form the airplane wing, this process can also be used to remove distortion caused by processing or heat treatment of complicated parts.
The process can improve the performance of lifting, and reduce oil consumption and environment pollution.
The shot peening formation can be used to meet requirements of surface curvature, thickness, shape, and reinforced rib and process deformation.